Refine by
Channel
Showing best results - all illustrated entries. Change the channel to view specific categories.
Base units for smoke and fire detectors
(12)
Base units for smoke and fire detectors on BUILDING SERVICES. Helping you find the best solution for your project.
Base units for smoke and fire detectors - helping you find the best solution for your project.
The Series 65 range of conventional detectors incorporates well-proven sensing technologies, together with advances in materials and electronics technology. The Series 65 12V relay base is designed for use in both fire and security systems. For fire systems, a jumper on the PCB is fitted to a latching position. For security systems the jumper is- PRODUCT
- Apollo Fire Detectors
The Series 65 range of conventional detectors incorporates well-proven sensing technologies, together with advances in materials and electronics technology. The Series 65 standard relay base provides one set of volt-free changeover (from C) contacts that change state when the detector signals an alarm. Features: Advanced electronic technology- PRODUCT
- Apollo Fire Detectors
The Series 65 range of conventional detectors incorporates well-proven sensing technologies, together with advances in materials and electronics technology. The Series 65 standard mounting base has been designed to enable detectors to be fitted without the need of force. It is particularly useful when fitting to suspended ceilings. All Series 65- PRODUCT
- Apollo Fire Detectors
The Discovery intelligent mounting base requires only a low insertion force for installation, making it suitable for use on suspended ceilings. It has stainless steel contacts for the detector terminals and is supplied with an XPERT card. All detectors in the Discovery and XP95 ranges fit into the intelligent mounting base- PRODUCT
- Apollo Fire Detectors
The Series 65 range of conventional detectors incorporates well-proven sensing technologies, together with advances in materials and electronics technology. The Series 65 auxiliary relay base provides two sets of volt-free changeover contacts to facilitate the switching of a remote LED or other auxiliary device. Features: Advanced electronic
AlarmSense is a range of conventional detection and alarm products specially designed to be connected to the same pair of supply wires. AlarmSense mounting bases are specifically designed for the mounting of AlarmSense detectors. They are fitted with electronic circuitry to monitor the presence of detectors and allow a fault to be signalled if a- PRODUCT
- Apollo Fire Detectors
The Series 65 range of conventional detectors incorporates well-proven sensing technologies, together with advances in materials and electronics technology. The Series 65 diode base is designed for use with conventional systems that have manual call points and detector bases on the same circuit. The base is fitted with a schottky diode on both the- PRODUCT
- Apollo Fire Detectors
The Series 65 range of conventional detectors incorporates well-proven sensing technologies, together with advances in materials and electronics technology. The Series 65 end-of-line (EOL) relay base is intended for use with four-wire circuits. It features two sets of changeover contacts and a power supervision relay. Features: Advanced electronic- PRODUCT
- Apollo Fire Detectors
The Discovery intelligent heater base is designed to be used in cold climates where environmental conditions could result in either icing or condensation affecting the operation of detectors- PRODUCT
- Apollo Fire Detectors
The Discovery isolating base senses and detects short-circuit faults on Discovery and XP95 loops and spurs
Base units for smoke and fire detectors - helping you find the best companies for your project.
Apollo Fire Detectors
Manufactures fire detection equipment, including ionisation and optical smoke detectors, rate-of-rise and static-response heat detectors and multisensor detectors. Detection devices with variable sensitivity modes are suitable for environments with changing conditions, and can be adjusted for installations in areas from cleanrooms to warehouses
36 Brookside Road, Havant, PO9 1JRNoby UK
Manufactures the Aurora range of conventional fire detectors. Capable of working with the majority of control panels and fully compatible with all Noby fire panels
1F Mill Fold, Elland Road, Ripponden, Halifax, HX6 4DJ
